Electronic shelf label EE200 The EE200 is a E-ink based electronic shelf label with a screen size of 2” and with 802.15.4 based wireless communication.
Opticon EE200 Specifications Manual All information subject to change without notice. Document History Model Number: EE200 Specification Number: Edition: 2 Original Spec Number: Date: June 3 2012 Copyright 2012 Opticon. All rights reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated or converted to any electronic or machine readable form without prior written consent of Opticon.
Opticon EE200 Specifications Manual Contents 1. Abstract ....................................................................................................................................... 5 2. Overview ...................................................................................................................................... 5 3. Physical Features ....................................................................................................................... 6 3.1. Dimensions ........
Opticon EE200 Specifications Manual Table of Figures Figure 1: Dimensions .................................................................................................................... 6 Figure 2: product label ................................................................................................................ 10 Figure 3: product label dimensions ............................................................................................. 10 Figure 4: shipment box label .................
Opticon EE200 Specifications Manual 1. Abstract This manual provides specifications for the EE200 electronic shelf label (hereafter referred to as “ESL”). 2. Overview The EE200 is an E-ink based ESL with a 2.4GHz radio for data communication. This product uses Direct Sequence Spread Spectrum RF technology that allows for an ultra-low power consumption combined with a reduced sensitivity to background noise. That means less interference by other radios that operate in the 2.4GHz band.
Opticon EE200 Specifications Manual 3. Physical Features 3.1. Dimensions W 71.0 x H 33.0 x D 14.5 mm Figure 1: Dimensions 3.2. Weight 40 g (including batteries) 4. Environmental Specifications 4.1. Operating Temperature and Humidity Temperature: 10 to 50° C Humidity: 20% to 85% RH 4.2. Storage Temperature and Humidity Temperature: -20 to 60° C Humidity: 20% to 85% RH 4.3.
Opticon EE200 Specifications Manual 4.4. Drop resistance. There will be no sign of decreased performance after the following drop test: Drop the ESL from 0.5 M above the concrete floor (6 sides, 3 times each). Scratches or discoloration of the casing do not decrease product performance. 4.5.
Opticon EE200 Specifications Manual 5. Controls Items Specifications Remarks Type 8051 core 8-bit MCU Internal flash ROM 96KB Internal RAM 6 KB Clock frequency 32 MHz Active area W 45.8 x H 22.0 mm Number of dots W 200 x H 96 Dot pitch 111 Horizontal 111 Vertical Modulation DSSS Frequency 2394 ~ 2507 MHz Baud rate 250 Kbits / second CPU LCD Radio Dots per Inch Globally approved 2.4GHz band. 6. Electrical Specifications 6.1.
Opticon EE200 Specifications Manual 7. Radio Specifications Parameter Min Receiver sensitivity Nominal output power Frequency -3 Typ Max Unit Remarks -97 -89 dBm Over the entire temp. and operating voltage range 4.5 7 dBm 2507 MHz Over the entire temp. and operating voltage range dB Signal strength indication that can be reported to the base station 2394 Transfer rate 250Kbit/s RSSI range 100 7.1. Protocol Modified 802.15.4 (Physical layer and Media Access Control layer). 7.1.1.
Opticon EE200 Specifications Manual 8. Labeling 8.1. Product label The product label is affixed to the ESL as shown below. Figure 2: product label There are two barcodes on the label: The serial number on the top and the device’s MAC address below. The serial number barcode simply shows the 8-digit serial number that allows for a 100 million range of numbers. The MAC address barcode is shown below the serial number code; the MAC’s factory code is not shown to save some space.
Opticon EE200 Specifications Manual 8.2. Shipment box labels The shipment box labels are made from plain paper and are meant to show the regulatory information on the shipment box as well as the quantity and the serial numbers for the ESL’s in the box.
Opticon EE200 Specifications Manual 9. Accessories The EE200 can be fitted with a clip that allows for easy assembly to a shelf. Several types are available so contact your nearest Opticon dealer for more information on this. . 10. Packaging Specifications 10.1. Individual Packaging Specification The ESL’s do not need to be packed separately.
Opticon EE200 Specifications Manual 10.2. Collective Packaging Specification Put 8 stacks, containing 200 ESL’s inside a box and affix the shipment box label on the indicated position. Figure 6: Collective packaging Note: The “RO” mark labeled on the package tray or package box guarantees that the applicable product has passed our test of RoHS restrictions compliance (the restriction of the use of certain hazardous substances in electrical and electronic equipment, 2002/95 EC).
Opticon EE200 Specifications Manual 11. Regulatory Compliance 11.1. EMC FCC Part 15 Subpart B Class B This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1 ) this device may not cause harmful interference, and ( 2 ) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15 Subpart C Clause 247 (Spread spectrum radio systems) 11.2.
Opticon EE200 Specifications Manual 12. Safety Handle this product carefully. Do not deliberately subject it to any of the following. 12.1. Shock Do not throw or drop the ESL. Do not place heavy objects on the ESL. 12.2. Temperature Conditions Do not use the ESL at temperatures outside the specified range. Do not pour boiling water on the ESL. Do not throw the ESL into the fire. Do not leave the ESL on the dashboard of a car. 12.3. Foreign Materials Do not immerse the ESL in liquids.
Opticon EE200 Specifications Manual 13.
