User's Manual

Opticon user's manual
USER’S MANUAL PHL2700 TERMINAL / IRU2700 CRADLE
12
2.5.5 How to (re)place the main battery
in the terminal?
Only use batteries as specified in
paragraph 2.5.1.
If you have data stored, make sure the
backup battery is placed and full
enough, to avoid data loss.
Before installing a battery case with penlite
batteries:
Make sure you use the right battery size.
Place 2 batteries in the battery holder
aligning plus (+) and minus (-) ends as
shown on the battery holder.
The instructions for installing the rechargeable
battery pack are also applicable for the battery
case with penlite batteries.
Unlock cover: Open the switch (shift to
the right) and remove the battery case
cover (ref. 1)
Remove main battery: Hold the battery
case while pressing on both sides and lift
it (ref. 2)
Place main battery: Take the battery case.
Check if the charging contacts of the case
align with the contacts inside the battery
compartment (ref. 3)
Fit main battery: First press the pack
into the direction of the terminal nose.
Than press the pack tight into the housing
untill it cliks (ref. 4)
Fit cover: Place the battery case cover and
lock the switch (shift to the left)
(ref. 1)
!
!
USER’S MANUAL PHL2700 TERMINAL / IRU2700 CRADLE
13
2.5.6 How to (re) place the backup battery
in the terminal?
Make sure that the main battery
is full enough while changing the
backup battery.
Only use CR2032 Li
(Lithium, button type) battery.
Unlock cover: Open the switch (shift to
the right) and remove the battery case
cover (ref. 1)
Open lid: Place your thumbnail below the
saving of the lid to open it (ref. 5)
Remove backup battery: Take the old
battery out of the compartment.
Place backup battery: Make sure that the
positive side of the backup battery is
pointed upwards and place it in the
compartment (ref. 6)
Close lid: Press the lid downwards until it
clicks into the compartment
Fit cover: Place the battery case cover and
lock the switch (shift to the left)
(ref. 1)
!
!
2
3
4
1
3
----> open
close <----
2
5
6