Quick Guide
Dry Contact Connection
Power Connection
Event Code & PoE
OPTEX Beams
IP Camera
IP Video
Management
Software
Network
Switch
BATTERY-POWERED, WIRELESS & IP SOLUTIONS
Battery-Powered, Wireless Solution
IP Solution
Save Time & Money
From rooop HVAC protection to electrical
substations, the wireless-ready, iSeries
photobeams, and enclosures from OPTEX
can oer you a battery powered, wireless
solution for all your security needs. While
the wireless-ready versions are shipped
with an empty backbox that will accept
any manufacturer’s wireless transmitter,
the iSeries come with Inovonics EN1941
wireless transmitters pre-installed, allowing
even more time saved while on the job site.
The EN1941 monitors the DQ circuit, tamper
and primary alarm, while an included BCU-4
module monitors for low battery. A total of
four lithium batteries are also included to
power the beams.
Sensing Solutions
For IP Systems
When PIE-1 IP encoders are combined with
OPTEX beams & enclosures, a complete IP
powered detection solution is achieved.
You can now connect to all leading VMS
platforms to control IP cameras, and PIE-1 is
compatible with Power over Ethernet (PoE),
making it possible to supply power using a
PoE hub or switch. With the PoE connection,
alarm signal information can be exchanged
via IP protocol. In addition, only one LAN
cable is needed to connect PIE-1 to a PoE hub
or switch, reducing installation time & cost.
Value of a Wireless-Ready
Battery-Powered System
• Easy solution to sites where trenching is too
expensive or labor intensive.
• Can be installed in areas where power is not
readily available.
• No downtime to end-user. Businesses &
residents can operate as usual during install.
• Allows for a flexible solution in changing site
environments, such as construction sites.
• Can easily be added on to support existing
video or access systems.
EN5040T Repeater EN4232MR Receiver
EN7290 Receiver/
Interface for
VISTA 128/250
*If repeater is mounted
outdoors, ACC650
enclosure is required
Any PC
Application
Any Intrusion
or Access Panel
with Hardwired
Inputs
07