Installation Manual

receiver
transmitter
Ch1 Ch1 Ch1 Ch1 Ch3 Ch3
transmitterA receiverB transmitterCreceiverA transmitterB receiverC
1. Long distance protection
《
EXAMPLE
》
Ch1 Ch1 Ch1 Ch1 Ch2 Ch2
Ch3 Ch3 Ch3 Ch3 Ch4 Ch4
2. Double stacked long distance protection
3. Perimeter protection 4. Double stacked long perimeter protection
transmitter
receiver
transmitter
receiver
transmitter
receiver
transmitter
receiver
transmitter
receiver
transmitter
receiver
transmitter(Ch1)
transmitter(Ch3)
transmitter(Ch1)
transmitter(Ch3)
receiver(Ch1)
receiver(Ch3) receiver(Ch1)
receiver(Ch3)
transmitter(Ch1)
transmitter(Ch3)
transmitter(Ch2)
transmitter(Ch4)
receiver(Ch1)
receiver(Ch3)
receiver(Ch2)
receiver(Ch4)
receiver(Ch2)
receiver(Ch4)
transmitter(Ch2)
transmitter(Ch4)
transmitter(Ch1)
transmitter(Ch3)
receiver(Ch1)
receiver(Ch3)
＋
－
＋
－
COM.
＋
－
N.C.
N.C.
｝
｝
＋
－
＋
－
＋
－
N.C.
Power
12VDC
｝
< Operating time chart >
D.Q. will send a trouble signal which indicates the adverse weather condition when the beam strength is being kept more than 40
seconds.
adverse weather level > the beam strength > alarm output level
< Example >
N.C.
(Alarm)
Alarm
Power
12VDC
Alarm1
Alarm2
OFF
ON
2 sec
40 sec
D.Q.
Beam
Strength
Adverse Weather Level
Alarm Output Level
N.C.
(D.Q.)
transmitter
transmitter
receiver
receiver
Control Panel
Control Panel
External Relay
Note
COM.
COM.
N.C.
(D.Q.)
COM.
COM.
Power
GND
Load
N.C.
(Alarm)
N.O.
A
C
B
6. WALK TEST
Make sure that the Alarm Indicator is OFF. If
it is illuminated even when the beams are not
blocked, make optical alignment again.
Be sure to conduct a walk test (to block the
infrared beam) at the following tree point:
A. In front of the Transmitter
B. In front of the Receiver
C. At the middle point between the
Transmitter and the Receiver
If the Alarm Indicator is not turned on after beam interception, check for the operation with reference to “9. TROUBLE
SHOOTING.”
2. Walk test
Make sure to check for the operation after installation.
Alarm Indicator
1. Checking by the Alarm Indicator
Note
7. SPECIAL FUNCTION * TF ONLY
7-1 ENVIRONMENTAL DISQUALIFICATION
Use the COM. terminal for both alarm
output and D.Q. circuit.
If there are refl ective things such as a fence,
stop at the position C. once and make sure
that the detector operates correctly.
By using external relay (N.O.), alarm
output can be cancelled while D.Q. send
signal.
[Alarm Output Cancellation][D.Q. + Alarm]
More than double stacked apprication is not possible.
<

Receiver >