Installation Manual

Distances between the Receiver and the Transmitter
Wiring
Hole
View Finder
Vertical Alignment
Screw
Terminals
•Transmitting
Condition LED
(Transmitter)
•Alarm Indicator LED
(Receiver)
Monitor Jack
(Receiver)
Horizontal
Alignment Dial
Waterproof Plug
Selection Dip Switch
(See "4 WIRE
CONNECTION",
"5-2 BEAM
INTERRUPTION
TIME", and "7-2
ALARM MEMORY *
TF ONLY")
3.3ft.(1m)
Alarm Memory
(Receiver)
(See "7-2 ALARM
MEMORY * TF
ONLY")
Selection Switch
(See "5-3 4
SELECTABLE BEAM
FREQUENCIES * TF
ONLY")
1) Loosen the cover lock screw to detach the cover.
2) Turn the optical unit and open the waterproof plug.
3) Loosen the unit base lock screw and slide the mounting plate
downward to detach the unit base.
1. PRECAUTIONS
2. Do not install the unit where objects
moved by the wind such as plants and
laundry, which may block the beam.
1. Mount unit only on a solid surface.
4. A different type of beam
should not reach the receiver.
3. Prevent direct sunlight
from entering into internal
receiver.
5. Avoid aerial wiring.
6. Do not install the unit
on unsteady surfaces.
receiver
transmitter
(other model)
transmitter
3
2. PARTS IDENTIFICATION
Optical Unit
Cover
Unit Base
Mounting Plate
Pole-mounting Bracket
3. INSTALLATION
・
Pole size should be 1 1/4”-1 7/8” (
φ
32-48mm).
(Standard U.S. 1 1/4” or 1 1/2”pipe)
ex) AX-70TN : 70ft.(20m)
2.3ft.-3.3ft. (0.7-1m)
180

(
±
90

)
10

(
±
5

)
Horizontally
Vertically
about 2.0ft.(60cm)
about 3.3ft.
(1m)
It is not recommendable to install the units in this way
(or direction). In case you do this installation, maximum
detection range shall be half of the original detection range.
(This is to prevent the attenuation of beam by the edge of
the cover.)
1. Detach the cover and the screw 2. Fix the mounting plate
When removing the cover, do not put your fi ngers
on the hood, whitch may cause damage.
Cover Lock Screw
Hood
Optical Unit
Waterproof Plug
Unit Base lock Screw
Wall Mounting Screws
Mounting Plate
Wall mounting Pole mounting (1 plate) Pole mounting (2 plate)
Mounting Plate
Lock Screws
Pole Lock Screws
7. Mount the units more
than 1m away from the
wall or fence.
Note
3-2. INSTALLATION METHOD
3-1. NOTE
1. Detection range and installation 2. Alignment angle 3. Pole mounting