User's Manual

2.8 Installation Example

USHR-1900H can be installed with multiple indoor antennas as shown in Figure 2-

8. In this example, a 6-way power splitter was used to split the signal to and from

the indoor antennas.

3. Operation

3.1 Introduction

This section provides information for operating the USHR-1900H bi-directional

amplifier.

3.2 Operating Instruction

3.2.1 Power-up

Connect the bi-directional amplifier to AC/DC Adaptor. Turn on Power Switch. If

no FAIL condition is present, only the “POWER” LED will remain lit. The bi-

directional amplifier is then operating properly.