User's Manual

Page 9
4.2 Insufficient Outside Signal Problem
After repeater installed, if there is insufficient outside signal around your
vehicle such as uncovered signal area, you may not use your mobile phone
4.3 Vehicle Battery Discharge Problem
Verify cigarette power code LED light is on as shown below. If not, check
either vehicle key is appropriately positioned or engine is on. In case of
battery discharge, replace battery.
4.1.5 ① There is a insufficient isolation between inside and outside antenna
② While installing if LED light blinks three times, move the inside and
outside
antenna away and turn on/off and move antenna as needed.
③ If there was no blinking problem while set up but happens after, it
could be caused by surrounding structure but that could be come
back to normal if you move to different location.
4.1.6 ① Repeater CPU software is checking out if there are any
problems such as isolation, overload or conciliation.
② On alarm checking status repeater is not operating