ASSEMBLY INSTRUCTIONS Description .
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. IMPORTANT NOTE: - - - Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
STEP 1 Use the Allen key (12) to loosen bolts and washers, and then remove the crossbar from bottom of the table top (A) as shown below. Attach crossbar and pedestal extension (D) to the column (C) with long bolts (9), short bolts (1), washers (2), (3), (10) and (11) as shown below. Tighten with Allen key (12).
Unlock the table top on both sides from underneath the top. Pull the 2 parts of the table top apart and remove the leaf as shown below. Attach the top (A) and pedestal extension (D) to the column (C) with long bolts (9), short bolts (1), washers (2), (3), (10) and (11) as shown below. Tighten with Allen key (12).
Attach mounting plate and pedestal extension (D) to the column (C) with long bolts (9), short bolts (1), washers (2), (4), (10) and (11) as shown below. Tighten with Allen key (12).
STEP 2 Attach pedestal extension (D) to the column (C) with long bolts (9), and washers (10) and (11) as shown below. Tighten with Allen key (12). Attach crossbar and pedestal extension (D) to the column (C) with long bolts (9), short bolts (1), washers (2), (3), (10) and (11) as shown below. Tighten with Allen key (12). T-6P GOES WITH T-36RXT Attach the top (A) and pedestal extension (D) to the column (C) with long bolts (9), short bolts (1), washers (2), (3), (10) and (11) as shown below.
Attach mounting plate and pedestal extension (D) to the column (C) with long bolts (9), short bolts (1), washers (2), (4), (10) and (11) as shown below. Tighten with Allen key (12).
STEP 3 Carefully put the pedestal block on the bottom side of the table top, attach crossbar to the top (A) with bolts and washers (from step 1) as shown below .Tighten with the Allen key (12). Place the leaf in the center of the open table top. Push the table top closed. Lock the mechanism underneath two sides of the table top as shown below.
Carefully put the pedestal block on the bottom side of the table top, attach mounting plate to the top (A) with bolts (1), and washers (4) and (3) as shown below .Tighten with the Allen key (12). Hold the drop leaf push and slide the wooden piece from underneath the table top. To lower the drop leaf, carefully hold the drop leaf with one hand and slide the wooden piece from underneath the table top towards the center of the top. Then, gently lower the leaf and place in the down position.
