Owner Manual

Step 3
Place the Back with Legs(B) on a clean, non-marring surface.
Align the mounting positions on the Seat(A) to the mountings on
the Back with Legs(B).
Lock the middle mounting position first, by using Bolts(①), Spring
Washers(②) and Washers(③) with Allen Key(④).
Then lock the corner four mounting positions and attach them
using Bolts(①), Spring Washers(②) and Washers(③) with Allen
Key(④), as shown on the picture above.
Frendly notice:
If the mouonting positions cannot be aligned well which hinders
the installation, then sway the Seat(A) lightly when locking the
Bolts, this action could help avoid the Bolts getting stuck and
ensure assemble smoothly.
Do not fully tighten the Bolts.
①
A
B
C
C
④
Table
Page 5 OF 8