Datasheet
DS12110 Rev 5 215/231
STM32H743xI Package information
227
Device marking for LQFP176
The following figure gives an example of topside marking versus pin 1 position identifier
location.
Other optional marking or inset/up
set marks, which depend on supply chain operations, are
not indicated below.
Figure 77. LQFP176 marking example (package top view)
1. Parts marked as “ES”, “E” or accompanied by an Engineering Sample notification letter, are not yet
qualified and therefore not approved for use in production. ST is not responsible for any consequences
resulting from such use. In no event will ST be liable for the customer using any of these engineering
samples in production. ST’s Quality department must be contacted prior to any decision to use these
engineering samples to run a qualification activity.
06Y9
3LQLGHQWLILHU
(6+,,7
<::
5
'DWHFRGH
3URGXFWLGHQWLILFDWLRQ
5HYLVLRQFRGH