Datasheet
Package information STM32H743xI
210/231 DS12110 Rev 5
Device marking for LQFP144
The following figure gives an example of topside marking versus pin 1 position identifier
location.
Other optional marking or inset/up
set marks, which depend on supply chain operations, are
not indicated below.
Figure 73. LQFP144 marking example (package top view)
1. Parts marked as “ES”, “E” or accompanied by an Engineering Sample notification letter, are not yet
qualified and therefore not approved for use in production. ST is not responsible for any consequences
resulting from such use. In no event will ST be liable for the customer using any of these engineering
samples in production. ST’s Quality department must be contacted prior to any decision to use these
engineering samples to run a qualification activity.
06Y9
'DWHFRGH
3LQLGHQWLILHU
(6+=,7
< ::
3URGXFWLGHQWLILFDWLRQ
5HYLVLRQFRGH
5