Data Sheet

O
mni
TM
ision
DESCRIPTION OF CHANGES (CONTINUED)
• In Table 6 on page 21, changed description of register 0x93 from “Edge Enhancement
Strength High Point Control” to “Sharpness (Edge Enhancement) Strength Lower Limit”
• In Table 6 on page 22, added “gain × 0x20” to description of register CNST (0x9C)
• In Table 6 on page 22, changed name, default value, R/W status and description of register
0x9D to “RSVD”, “XX”, “–”, and “Reserved”, respectively
• In Table 6 on page 22, changed description of register SCAL0 (0xA0) from “Scaling
Control 0” to:
DCW Ratio Control
Bit[7:4]: Reserved
Bit[3:2]: Vertical down sampling select
00: Bypass
01: 1/2 vertical down sampling
10: 1/4 vertical down sampling
11: 1/8 vertical down sampling
Bit[1:0]: Horizontal down sampling select
00: Bypass
01: 1/2 horizontal down sampling
10: 1/4 horizontal down sampling
11: 1/8 horizontal down sampling
• In Table 6 on page 22, changed description of register SCAL1 (0xA1) from “Scaling
Control 1 – for horizontal scaling control” to:
Horizontal Zoom Out Control
• In Table 6 on page 22, changed description of register SCAL2 (0xA2) from “Scaling
Control 2 – for vertical scaling control” to:
Vertical Zoom Out Control
• In Table 6 on page 23, changed description of register SDE (0xA6) from “Special Digital
Effect Control” to:
Special Digital Effect Control
Bit[7]: Reserved
Bit[6]: Negative image enable
Bit[5]: Gray scale image enable
Bit[4]: V fixed value enable
Bit[3]: U fixed value enable
Bit[2]: Contrast/Brightness enable
Bit[1]: Saturation enable
Bit[0]: Hue enable
• In Table 6 on page 23, added “gain × 0x40” to description of registers USAT (0xA7) and
VSAT (0xA8)
Horizontal zoom ratio =
0x40
SCAL1[7:0]
Vertical zoom ratio =
0x40
SCAL2[7:0]