User's Manual

BLU ETOOTH ST EREO H EADSET

Pairing Headset with Bluetooth Phone

z Mount battery onto Headset. Click and hold ‘Vol Up’ & ‘ON/OFF’

buttons together for more than 4 seconds. When LED lights up and

starts to flash, release the two buttons. LED will then flash continously.

This pairing mode will last 3 minutes and if no pairing is made within

this period, the Headset will return to standby mode. For SE P800

and Sharp GX-30 phones, use ‘Vol Down’ & ‘ON/OFF’ buttons to

enter pairing mode.

z Manipulate the buttons or menus of phone to complete pairing. (Refer

to phone manual as the instructions may differ from device to device).

Check if SONORIX Stereo Headset is displayed in the list of

searched devices. If not found, repeat pairing procedure.

z When prompted to enter PinKey, enter ‘0000’ which is the fixed

PinKey for Bluetooth Stereo Headset.

z The Headset can be paired with up to 10 different devices. Pairing is

done just once and not every time a different device is used.

Using the Headset to Make a Call

z Make sure Headset and mobile phone are connected and

microphone plugged into USB port of Headset.

z To make a call, dial from the mobile phone and when the dial tone is

heard, click ‘MFB’ button once to switch over to Headset.

z To end the call, press the “MFB” button once.

Note : For some phones, the “ON/OFF” button is used to end the call.

z For Bluetooth phones that support Handsfree Profile, clicking the

“MFB” button in a long manner will activate the phone to redial to the

last number received or called.

Notes : For redialling, the procedures may differ from one device to

another. For some phones, clicking the “MFB” button in a long

manner will first activate the phone to display the list of the last

numbers received or called. For others, clicking the “MFB” button in a

long manner will redial to the last number received or called directly.

PINKEY : 0000