User's Manual

Pairing H3 with Bluetooth Device

z To put H3 in pairing mode, in power off state, click

and hold MFB continuously until LED will changes

to alternating red and blue flash. Pairing mode

lasts for 3 minutes, after this period H3 returns to

standby mode.

z From a Bluetooth device, search for devices and

establish the connection. If prompted for pinkey,

enter ‘0000’ which is the pinkey for H3. When

connected, the LED will turn OFF.

Switching the H3 ON/OFF

z To switch on H3, click and hold MFB until Headset

LED lights up blue and change to periodic flashing

blue.

z To switch off H3, click and hold MFB until Headset

LED lights up red and then turn OFF.

Wearing the H3

z The headset can be worn on left or right ear. Select

any one of the two rubber gels that fit your ear

secure and comfortably.

z Place the headset in the ear such that the rubber

gel holds the headset against the ear wall and

stays comfortably.

z When not using the headset, you can connect the

headset to clip attached to lanyard.