User Manual

21
CONNECTING TO THE CONTROL BOX RADIO SOCKET
The Radio socket is for connecting your Two Way Radio.
To connect your Two Way Radio to the Control Box complete the following steps:
1. Ensure that the Control Box and Two Way Radio are in Power Off mode.
2. Insert the Two Way Radio Connection Cable 3.5mm pin into the Control Box socket
labeled Radio.
3. Insert the other end of the Two Way Radio Connection Cable into your Two Way
Radio.
 You can now Power On your Two Way Radio and adjust any settings as required.
NOTE: Some trial and error is required to determine the optimal placement of your Two
Way Radio in relation to the Control Box to reduce any feedback.
CONNECTING TO THE CONTROL BOX AUX1 AND AUX2 SOCKET
The AUX1 and AUX2 sockets are identical and are normally used for connecting your
Navigation Device or Radar Detector.
To connect to the AUX1 and AUX2 sockets complete the following steps:
1. Ensure that the Control Box and device are in Power Off mode.
2. Insert the included Connection Cable into the device; insert the other end of the
cable into the Control Box socket labeled AUX1 or AUX2.
 You can now Power On your device and adjust any settings as required.
CONNECTING TO THE CONTROL BOX AUDIO SOCKET
The Audio socket is normally used for connecting your Audio Player.
To connect to the Audio socket complete the following steps:
1. Ensure that the Control Box and Audio Player are in Power Off mode.
2. Insert the included Connection Cable into the Audio Player; insert the other end of
the cable into the Control Box socket labeled Audio.
 You can now Power On your Audio Player and adjust any settings as required.
CONNECTING WIRELESS DEVICES TO THE CONTROL BOX
The Control Box is equipped with Bluetooth
®
wireless technology enabling up to two
connections with other devices also equipped with Bluetooth wireless technology such as a
mobile phone or navigation device. Additionally the Control Box maintains two preset
wireless connections with the two Helmet Headsets; you do not need to perform any setup
procedure between the Helmet Headsets and the Control Box.
CONNECTING THE HELMET HEADSETS TO THE CONTROL BOX
The Helmet Headsets have a preset wireless connection with the Control Box; you do not
need to perform any setup procedure between the Helmet Headsets and the Control Box.
For simplicity the Control Box connects with each Helmet Headset successively, first
connecting with the Helmet Headset Rider and then with the Helmet Headset Passenger.
When connecting the Helmet Headsets to the Control Box you should first Power On both
the Helmet Headset Rider and the Helmet Headset Passenger, then Power On the Control
Box.