User's Manual

27
6. The minimum intercom activation volume level has been achieved when the status
light displays a still red and blue light for four seconds.
NOTE: Some trial and error is required to determine the appropriate intercom activation
volume.
OPERATING BIKE TO BIKE INTERCOM
Half duplex intercom communication is enabled between two or more bikes equipped with a
BikerCom system and connected Two Way Radio; Bike to Bike Intercom is enabled using
Two Way Radio service. Only the Rider’s voice can be transmitted over the Two Way Radio;
the Passenger can only receive the Two Way Radio transmission.
The following instructions will guide you through Bike to Bike Intercom operation:
1. Ensure that the Helmet Headset Rider and Passenger are connected to the Control
Box and functioning on all bikes.
2. To transmit a message press and hold the Push To Talk Button on the left handlebar
and speak into the Helmet Headset microphone, if you are listening to music the
music will automatically mute.
3. When you have finished transmitting your message release the Push To Talk Button;
if you were listening to music the music will return after approximately 10 seconds.
OPERATING AUX1 AND AUX2 WIRED CONNECTIONS
The AUX1 and AUX2 sockets are identical and normally used for connecting a navigation
device or a radar detector; connecting a navigation device enables you receive navigation
instructions, connecting a radar detector enables you to receive radar detector alerts.
The following instructions will guide you through operating a device connected to the AUX1
and AUX2 wired connection:
1. Ensure that the Helmet Headset Rider and Passenger are connected to the Control
Box and functioning.
2. Ensure that the device is connected to the Control Box and functioning.
3. Navigation instructions and radar detector alerts are heard by both the Rider and
Passenger.