Smart Button Switch HS2 User Manual
QUICK START GUIDE +4 1. Insert the included 1 CR2450 button cell battery and close the cover. 2. Make sure the Bluetooth of your iOS device is on. 3. Use the Home app, or download the free Onvis Home App and open it. 4. Tap the ‘Add accessory’ button, and scan the QR code on the HS2 to add the accessory to your HomeKit network. Note: When QR code scanning is NOT applicable, select the target device (last 6 digits matching the MAC address), and manually input the SETUP code printed on the cover page.
Product Description Onvis Switch HS2 is a 5-key, Apple HomeKit compatible, Thread+BLE5.0 battery powered multi-switch. It controls HomeKit devices and set scenes handily. Onvis Switch HS2 Overview LED indicator Reset Buttons (button 1 + button 5) Magnetic base • 5 Keys • Single, double and long press • Magnetic base, adhenive stickers & screws • Records Restore Factory Settings Long press the button 1 + button 5 (round button + button with 5 dots) at the same time for about 15 seconds.
Specifications Wireless connection: Thread + Bluetooth Low Energy 5.0 Operating temperature: 14℉~113℉(-10℃~45℃) Operating humidity: 5%~95% RH Dimensions(L×W×H): Switch 2.17*2.17*0.79 inch (55*55*20mm) Base 2.32*2.32*0.39 inch (59*59*10mm) Color: White Usage: Indoor use only Battery: CR2450 button cell battery, 650mAh Standby time: 1 year Tips 1. Clean and dry the target surface before putting HS2 base on. 2. Keep the setup code label for future use. 3. Do not clean with liquid. 4.
FAQ 1. Why did I fail to set up my Onvis Smart Multi-switch HS2 to Onvis Home app? (1) Make sure Bluetooth is enabled in your iOS device. (2) Make sure your HS2 is within connecting range of your iOS device. (3) Before set up, reset the device by long pressing the button in the center for about 15 seconds until LED blinks red, green and blue once. (4) Scan the setup code on the device, instruction manual or inner packaging. (5) If the app prompts ”couldn’t add the device” after scanning the setup code: a.
FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
瀊瀊瀊濁瀂瀁瀉濼瀆瀇濸濶濻濁濶瀂瀀 support@onvistech.
