User Manual
-8 -
5. Open the SIM-card holder by dragging it down until there is a click.
6. Fold up the upper part.
7. Insert the SIM-CARD in the upper part (the up folded part). The cut corner shall be positioned
in the upper left corner when the upper part is folded down
8. Fold down and drag the upper part up until there is a click. The SIM-card is now locked into
position.
9. Open the screw cap by turning it counter clockwise.
10. Pull the cables through the screw cap.
11. Connect the number of units that you wish to use:
a. Power. Terminal A, 12VDC. Use either the power adapter or a 12V accumulator or
both. Plus (white cord) is connected to the connector “+12-24VDC”. Minus (black
cord) is connected to the connector “GND”. 24VAC does work, though it might
damage the unit if the higher voltage than 27VAC is connected to the unit.
Important. Do not connect to a power source at this stage. This might cause
damage to the equipment.
b. Relay. Terminal B. If you want “Normally Open Relay” (Closing relay) use connector 2
and 3. If you want “Normally Closed Relay” (breaking relay) use connector 1 and 3.
Maximum load is 230VAC 10A.
Important. If you shall connect main power, contact a professional electrician.
c. Alarm. Terminal A. Alarm A is connected to connector “+3.8V” and “A”. Alarm B is
connected to the connector “3.8V” and “B”.
d. External temperature is connected between “Temp” and “GND”- connectors.
e. Connect the GPS receiver to terminal “C”.
12. When all the cables are in place, simply turn the screw cap clockwise to create a tight seal.
You can also use plastic tape around the bundle of cables to create a thicker and tighter seal.
13. Pull the hood over the unit and make sure that no cords are pinched or jammed. Put the
screws back into their positions. Also attach a screw in the hole on top of the hood.
14. Connect the power cable to the accumulator and/ or the power adapter to the mains.
a. Make sure that the green lamp starts to flash for about 15 seconds. This indicates
that the unit is searching and is trying to connect to a GSM network.
b. The unit is connected to the GSM network when the green lamp is showing a
constant green light and the unit is now ready for use.
Notice. If the green and the red lamp keeps flashing this means:
No SIM card is inserted.
The PIN code of the SIM card has not been deactivated.
The SIM card has not been inserted properly.
Choose a Password
To communicate with the unit you must choose a password. This is to make sure that no
unauthorized should be able to connect to the unit. The password contains four digits.
1. Create a password by sending an SMS to the unit with four digits. These four digits is stored
within the unit and is your password. This is to guarantee the units confidentiality.