User Manual

-6 -
Relay 9015 there is two wired alarm inputs that can be set to operate with either Normally
Open or Normally closed function. The unit also contains a temperature sensor.
 Ontech Alarmbox 9012 is a small battery powered unit containing a magnetic switch that
sends an alarm if the magnetic switch is activated. The unit also has a wired input that can be
connected to alarm sensors with either Normally Open or Normally closed function. Different
types of alarm sensors can be connected, for example fire alarms, PIR, magnet switches, level
guards etc. Either the magnetic switch or the wired inputs can be used. It also has a built in
temperature sensor that upon request reports the temperature. The battery will work for
approximately 3 years with normal use and the unit will also warn when the battery level is
low.
 GPS-receiver. There is a number of GPS-receivers compatible with Ontech GSM 9025. Consult
Ontech web site for more information, www.ontechgsm.com.
External temperature sensor
An external temperature sensor (not included) can be connected in the Temp input contact on the
bottom side. The unit can be set to use either the internal temperature sensor or the external
temperature sensor to control the temperature alarm or the Thermostat function (see Function
settings on page 15). The status message will show the value from both temperature sensors. The
cable is two meters but can easily be extended to up to 10 meters.
Cut the connector on the temperature sensor and remove about 3 mm of the insulation on the leads.
Connect the leads to Terminal A connectors Temp and GND.