User Manual

-30 -
3. Wait at least 60 seconds.
4. Press down the button.
5. Connect the unit to the main power socket while still holding the button down.
6. The red lamp blinks 8 times.
7. Release the button.
8. The unit has now been restored to factory settings and starts to search for the GSM network.
9. Start using it by setting the Password, see Choose a Password on page 8.
Backup battery
There is a backup battery in the unit that power the unit in case of a main power failure. One minute
after a main power failure an SMS is sent to all mobile numbers on the Alarm list with the message
”No main Power”. You can set how many minutes delay you wish before the SMS is sent. See the
Function settings on page 15. When the main power is restored a new SMS with the text ”Main
Power restored” is sent.
The backup battery can power the unit for 10-20 hours. When the battery is low an SMS will be sent
to all numbers on the Alarm list with the text ”Internal battery empty. Unit shuts down”. Then the
unit will disconnect from the GSM network and turn off.
In Android telephone with the Ontech Control app installed these messages will be presented
graphically.
When the unit is powered by the backup battery the 230 V outlet is turned off.
When the main power is restored the 230 V outlet will go back to the position it had before the
power failure.
The alarm functions are still activated during a main power failure.
Powering with Alternating Current
The unit can also be powered with 24 ACV .
The connection is made on connection terminal A to connector “+12- 24VDC” and “GND”.
Important! No higher voltage than 27 VAC may be connected. This may cause damage to the unit.