User Manual

-25 -
Other functions
Thermostat function
The Thermostat function controls relay with input values from the temperature sensor. If you
connect a radiator or similar to the relay and turn on the Thermostat function (see Controlling the
unit on page 17) the unit will automatically turn on when the temperature drops one degree below
the set temperature value and turn off when the temperature rise one degree above the set
temperature value.
Values between 0 and 29 degrees are permitted.
The Thermostat function is turned off by sending a command to the unit (see Controlling the unit on
page 17) or by pushing the button on the unit.
Garage Opener function for Android
Important! Can only be operated from Android telephones with the Ontech Control app installed.
This function differs between Android and Iphones. Below contains a description for the Android
phone. For Iphone, see Garage opener for Iphone on page 26.
With this function you can make the unit recognize up to three mobile numbers. When any of these
numbers are calling the unit the relay will turn on for one second and then turn off without
answering the call. This function can be used to open a garage gate when an approved person calls
the unit.
Launch Garage Opener
Press the Android general button for settings. Four buttons will appear on the lower part of the
screen. (If you cannot find it, see troubleshooting guide on page 31. Press Garage Opener. If there is
an alert message you can ignore it. The below screen will appear.