User Manual

-23 -
Text in SMS – example
Explanation
Alarm:
This row will be shown only if an alarm sensor has been activated
IntTemp
Indicates that a temperature alarm has been activated by the internal
temperature sensor. If the text is ExtTemp instead, it is the external
sensor that has triggered the alarm.
5;--
Indicates the present temperature, the first value is the internal
temperature sensor, the second value (if there is any) is the external
temperature sensor.
Temperature alarm to an Android telephone
If the app Ontech Control is installed there will be a voice message saying “Ontech Alarm”
On the main screen the background of the icon for the alarm will be red.
The background of the temperature value will be red to show the temperature measured by the
temperature sensor.
Power fail alarms
In the unit there is an internal backup battery (see Backup battery on page 30) that will power the
unit if there is a main power failure. One minute after a power break the power fail alarm message
will be sent to all numbers on the Alarm list with the message “No main Power”. You can set how
many minute you want to delay the power fail alarm. Do this with the Powerfail function (see
Function settings on page 15).
When the main power is restored you will receive a news message saying “Main Power restored”.
The backup battery can power the unit 10-20 hours. When the internal battery is low a message will
be sent to all numbers on the Alarm list with the text ”Internal battery empty”. Unit shuts down”.
Then the unit disconnects from the GSM network and turns off.
On Android telephones with the Ontech Control app installed there will be a graphic presentation of
the messages.
The power fail alarm function is activated by default and will thus work also when the general alarm
function not is activated.
All wired and wireless alarms will still work when the unit is powered by the internal backup battery.
The 230 V outlet is turned off when there is a power fail. The outlet will return to the same position it
had before the fail when the power is restored.
GPS alarm
The GPS alarm is a function that will alarm when the unit has moved outside a specific area. This area
is circle based and has a radius of at least 50 meters. The radius can also be multiplied (50m, 100m,
150, etc.).
At www.ontechgsm.com you will find information regarding which GSM receiver that is compatible
with our products. In most cases an adapter is necessary. The adapter is connected to plug C (See
picture on page 9)
With the function GPSFENCE (See Function settings on page 15) you can set the size of the area you
wish to guard. The unit will alarm when the unit is moving outside the area for more than one minute
after it has been activated.