User Manual

FUSB307BGEVB
www.onsemi.com
13
VDM
This tab enables supports Vendor Defined Messages
(VDM). The “Configuration” section is used for configuring
the FUSB307B. The upper left “FUSB305” section window
is used for displaying and modifying or adding VDM
information to the EVB. Right-clicking on the Sop field
allows you to add SVIDs. Right-clicking on an SVID allows
you to remove the SVID or add a Mode. Right-clicking on
a Mode allows you to remove it.
Retrieving VDM information from a connected device
can be done in the lower left “Other” section window.
Right-clicking on Sop allows you to request Discover
Identity or Discover SVIDs. Right-clicking on a SVID
allows you to request Discover Modes. Right-clicking on
a Mode allows you to request to Enter or Exit that Mode.
Figure 16. VDM Tab
Arm and Cortex are registered trademark of Arm Limited (or its subsidiaries) in the US and/or elsewhere.
USB Type−C and USB−C are trademarks of USB Implementers Forum.
ON Semiconductor is licensed by the Philips Corporation to carry the I
2
C bus protocol.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.