Installation Guide

EN FI NO SE
HEATING POWER LIMIT
If necessary, the total instantaneous heating power of the
thermostats can be limited, i.e. the average power during
each hour is below the set limit.
1. The system can have 2-20 thermostats
2. Wireless eco-controls must be enabled
3. The network key must be the same for all thermostats
involved in the power limitation
4. For each thermostat, the power of the heater it controls
and the maximum allowed network power are defined
Thermostats under power limitation are switched on and off
randomly but evenly.
NOTE!
The power limiting function is available from version:
Software V71 when the hardware is 4.0C
Version information can be found on the INFO page of the
phone's application