Installation Instructions

If there is any mistake with hand measure, subject to the actual product.
Note: Before tightening the screws, please ensure that all the tail wires are not crushed by the
screws, causing a short circuit.
②Wall-hanging type：Firstly,remove the stainless steel wall hangings from the device. And then
put the stainless steel plate on the wall at an appropriate height, drill four holes with an impact
drill, place the rubber plug in the hole, fix the stainless steel plate to the wall with tapping
screws.( If the tail wire comes out of the back of the box, it is necessary to make a hole in the wall
to facilitate the wiring. If the tail wire comes out from the bottom, it only needs to be fixed and
routed with a large white plastic trunking.) As shown in the figure.
Wires outlet diagram of Wall-mounted