Installation Instructions

B Instructions for appearance
①According to the requirements of the installation site, a space of 35mm in diameter is generally
opened in the middle or front of the gate, as shown in the figure, ⊕ is the recommended
opening position.
Single channel gate Double channel gate
Note: The position of the opening should be based on the actual application and the type of
gate， 35mm is only a reference .
Unscrew the nut at the bottom of the gate, pass the cable through the nut, and remove the nut,
as shown in the figure.
Note: Do not connect the network cable, power cable, etc. At this time to avoid installation
trouble
Under the gate, pass the cable and cable interface through the washer and nut in sequence, and
tighten the nut to the thread , as shown in the figure.