User's Manual

En-16
Troubleshooting
The LED is off
Make sure that the UP-AR1 is connected to the
Main device. (En-10)
The LED is blinking
Upon initialization, the LED blinks for about 1
minute while the UP-AR1 is connecting to the
Network. If the blinking persists, the Network
connection has failed. Check the Network setup.
(En-10)
Cannot connect to Wi-Fi (wireless LAN)
Make sure that your Wi-Fi router has support for the
following features:
802.11b or 802.11g standard.
Channel band of 1-11 ch.
There’s no sound
Make sure that the volume level of the Main
device is properly set.
Make sure that the PORT selector is selected .
Refer to the “Troubleshooting” section of the Main
device’s instruction manual.
•
•
•
•
•
•
•
The STATUS LED won’t go off
Since “Wake Up On AirPlay” is set to “On” by
factory default, the UP-AR1 remains switched on
even if the Main device is in standby mode. To
turn the UP-AR1 off, set “Wake Up On Airplay” to
“Off” before switching the Main device to standby.
(En-14)
•
UP-AR1_En.indd 16 2011/04/22 10:42:29