User's Manual

En-15
Firmware Update
Follow either of the procedure below to update the
firmware of UP-AR1.
Note
Don’t unplug the cables or turn the power off during
the update process.
Using the WPS button of UP-AR1
1
Press PORT followed by SETUP on the remote
controller.
2
Press and hold the WPS button for
10 seconds.
“F/W UpdateMode” is displayed on the Main
device, and the firmware update starts.
Wait until “Please Restart” appears.
3
Set the Main device to Standby mode or turn
its power off and then turn it back on.
This completes the firmware update. UP-AR1 is
now updated with the latest firmware version.
Tip
During the update process, the STATUS LED
on UP-AR1 will flash.
When the latest version is already installed, no
firmware update is made.
•
•
Using a personal computer
1
Download the firmware file from the Onkyo
web site.
2
Uncompress the downloaded file in any
folder.
3
Access the firmware update menu of the WEB
settings (En-14).
4
Browse for your uncompressed file and follow
the instructions on your computer screen to
perform the update.
“F/W UpdateMode” is displayed on the Main
device, and the firmware update starts.
Wait until “Please Restart” appears.
5
Set the Main device to Standby mode or turn
its power off and then turn it back on.
This completes the firmware update. UP-AR1 is
now updated with the latest firmware version.
For further details, visit the Onkyo web site. You
can find the home page address on the back of this
manual.
UP-AR1_En.indd 15 2011/04/22 10:42:29