User's Manual

En-11
Wireless connection
Note
Make sure that no Ethernet cable is connected. If an
Ethernet cable is connected, you must first unplug
the cable before continuing with the setting.
Performing the setup with the WPS button
(your Wi-Fi router must be WPS-capable)
1
Set the Main device power to on.
2
Press PORT on the remote controller.
Wait until “Starting” goes off on the Main
device’s display.
3
Press SETUP on the remote controller.
Note
While “Starting” is displayed on the Main device,
the SETUP button doesn’t work.
4
Enable the WPS mode on your Wi-Fi router.
5
Press WPS on the UP-AR1.
■
Performing the setup without the WPS
button
1
Set the Main device power to on.
2
Press PORT on the remote controller.
Wait until “Starting” goes off on the Main
device’s display.
3
Press SETUP on the remote controller.
The UP-AR1 enters Setup Mode.
Note
While “Starting” is displayed on the Main device,
the SETUP button doesn’t work.
4
Use q/w to select “Wi-Fi SetUp?” and then
press ENTER.
Follow either of the procedure below. Use q/w
to select an option.
■
UP-AR1_En.indd 11 2011/04/22 10:42:28