Manual

7X NR702,602 t n book Page 78 Monday,July 26, 2004 11:05 AM
Zone 2--Continued
Ol_rl.K",/O
I
I
3
RC'588M
Note:
To control Zone 2 with the remote controller, you must
press the [ZONE 2] button first.
Point the remote controller at the
AV receiver and press the
[ZONE 2] button followed by the
[ON] button.
This turns on Zone 2 and tile AV
receiver's 12V TRIGGER OUT.
To select the Zone 2 input source
with the remote controller, press
[ZONE 2] button followed by
an input selector button.
If you select AM or FM, you can use
the remote controller's ITUNER] but-
ton to select the band.
steps 1 and 2 on the
AV receiver, press the [ZONE 2]
button, and then use the Control-
ler [<1]/[1_] buttons within five
seconds.
The name of the selected Zone 2 source
appears on the display.
Notes:
To set Zone 2 to the same source as the
main room, press the IZONE 2] button,
and then use the Controller I_ll/l_l
buttons to select "Zone 2 Sel: Source."
To adjust the Zone 2 volume with
the remote controller, press the
[ZONE 2] button, and then use
the [LEVEL-] and [LEVEL+] but-
tons.
To do this on the AV receiver,
press the ZONE 2 [LEVEL] but-
ton, and then use the Controller
[<1]/[1_] buttons.
Ifthe Zone 2 receiver/integrated amp is
connected to the AV receiver's ZONE 2
LINE OUT L/R jacks, use the vohnne
control on the receiver/integrated amp.
To turn off Zone 2 with the
remote controller, press the
[ZONE 2] button followed by the
[STANDBY] button.
To do this from the AV receiver,
press the [ZONE 2] button, and
then use the Controller [<1]/[1_]
buttons to select OFF.
If the Sleep function has been set, the Zone 2 compo-
nent will turn off along with the AV receiver when the
specified sleep time expires. To use the Sleep function
with Zone 2 only, set the Sleep fimction and then set
the AV receiver to Standby.
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it's con-
nected to an analog input.
• Since the Zone 2 flmction and the REC OUT outputs
use the same circuitry, if the [REC OUT] function is
used, Zone 2 will be turned off.
• While Zone 2 is being used, listening modes that need
surround back speakers (i.e., Dolby Digital EX, DTS-
ES, and THX Surround EX) are unavailable.
• While Zone 2 is on, r'4! flmctions will not work.
• You can't select different radio stations for Zone 2 and
the main room. For example, if you an FM station for
the main room, that station will also be used in Zone 2.
78