Manual

TX NR702,602 t n bool_ Page 77 Monday,July 26, 20(14 11:(15 AM
Zone 2--Continued
To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
m
2,3--
&®®®j
2-4
aUDIO suanr_ aNGLE _SV_
@@@@
the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main mei_luappears onscreen.
Use the Up and Down [A]/[V]
buttons to select 1. Initial
}," and then press [ENTER].
The Initial Setup mei_lu appears.
Use the Up and Down [A]/[V]
to select "a. Powered
Zone 2:' and use the Left and
Right [<1]/[1_] buttons to select:
Menu
1.Initial Setup
1-3.Hardware Setup
b. Sp Impedance Minimum
:6ohms_
Not Activated: Zone 2 SPEAKERS
terminals deactivated.
2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see page 78), the speakers connected
to the ZONE 2 SPEAKERS terminals
but the speakers con-
BACK
SPEAKERS terminals do not. (When
activated but not used, the
surround back speakers work as nor-
mal.)
[SETUP] button.
i!iiThe setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and IENTER] button.
Use the Up and Down [A]/[V]
buttons to select "3. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
77