Manual

TX NR702,602 t r_book Page 55 b'kmday,July 26, 2004 11:05 AM
Basic Operation--Continued
You can display various information about the current
inpnt source as follows.
f
RECEIVER--
DISPLAY--
f
Press the [RECEIVER] button,
press the [DISPLAY]
button repeatedly to cycle
through the available informa-
The following information can typically be displayed for
input sources.
Input source & ,..., ,,...
volume L,__.,_L.,_ ':'i"{ii';
Signal format*
or sampling i) r'_ i }'",",' ii_ _ ':r ..--":_-_ l
frequency ................. " '_ "" ': :'_
Inputsource& :--.:1::"._ i'"_,'", _ :..,'...' :'"_ ]
listening mode ..................................
'qf the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is dis-
played t_r about three seconds, then the previously dis-
played information reappears.
Interpreting Surround Channel Values
-:5 ..' ""_ q
A B C
A: The number of front channels (3 means front left,
front right, and center).
B: The number of surround channels (2 means surround
left and surround right). If there's surround back
channel infommtion, this will be 3.
C: LFE channel for subwoofer (1 means yes).
55