Manual

TX NR702,602 t r_book Page 50 Rkmday,July 26, 2004 11:05 AM
First Time Setup--Continued
Speaker Level Calibration
This setting is set automatically by the Automatic
peaker Setup function (see page 39). ./
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Notes:
• The speakers cannot be calibrated while the output of
the AV receiver is muted, while a pair of headphones
is connected, or when using the multichannel input.
• Because the TX-SR702/702E supports THX, tile
test tone is output at the standard level of 0 dB
(absolute volume setting 82). If you normally listen
at volume settings below this, be careful because
the test tone will be much louder.
m
2,3--
II 1,6
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
Use the Up and Down [&]I[V]
buttonstose'ect" .Leve'Ca"-
bration," and then press
[ENTER].
TheLeve, ,'i' rationmenn ,ppears
and the pink noise test tone is output by
the front left speaker.
Not :
Speakers that you set to No or None on
the Speaker Configuration page
(page 46) cannot be selected.
Use the Up and Down [&]/[IV]
buttons to select each speaker,
and use the Left and Right [-<]/
[1_] buttons to set the volume.
The volume can be adjusted from 12
to+12dBinldBsteps( 15to+12dB
for the subwoofer).
Repeat step 4 until the volume of
the test tone from each speaker
is the same.
Press the [SETUP] button.
The setup menu closes.
Use the Up and Down [&]/[V]
buttons to select "2. Speaker
Setup," and then press [ENTER].
The Speaker Setup menu appears.
Notes:
• This procedure can also be performed by using the
remote controller. First press the ITEST TONEI but-
ton to output the test tone. Use the [LEVEL-] and
[LEVEL+] buttons to set the volume, and use the [CH
SEL] button to select the speakers.
5O