Manual

TX NR702,602 t n book Page 47 Monday,July 26, 2004 11:05 AM
First Time Setup--Continued
and Down [&]/[V]
buttons to select "c. Center," and
then use the Left and Right [<ly
[1_] buttons to select:
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
large.
None: Select if no center speaker is
connected.
Note:
If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
Use the Up and Down [A]/[V]
buttons to select "d. Surround,"
and then use the Left and Right
[<1]/[1_] buttons to select:
Smalh Select if the surround left and
right speakers are small.
Large: Select if the surround left and
right speakers are large.
None: Select if no surround left and
right speakers are connected.
Note:
If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
Use the Up and Down [A ]/[,]
buttons to select "e. Surround
Back," and then use the Left and
Right [<1]/[1_] buttons to select:
Small: Select if the surround back
left and right speakers are
small.
Large: Select if the surround back
speakers are large.
None: Select if no surronnd back
speakers are connected.
Notes:
If the Surround setting in step 7 is set
to None, this setting cannot be
selected.
• If the Surround setting in step 7 is set
to Small, this setting cannot be set to
Large.
Crossover
connected.
with step 10 in the right col-
Use the Up and Down [&]/[V]
to select "g. Crossover,"
and then use the Left and Right
[<1]/[1_] buttons to select a
crossover frequency.
Choose a crossover frequency suitable
for your setup. If you're using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
peakers. If yot£re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
For the TX-SR702/702E, if you're
using THX-certified speakers, select
80Uz (THX).
Speaker cone
diameter
Over 12 in.
(30 cm)
8 to 12 in.
(20-30 cm)
6-1/2 to 8 in.
(16-20 cm)
5-1/4 to 6-1/2 in.
(13-16 cm)
3-1/2 to 5-1/4 in.
(9-13 cm)
Under 3-1/2 in.
(9 cm)
Crossover
frequency
40Hz*
60Hz
80Hz (THX)
100Hz
120Hz
150Hz
'_TX-SR702/702Eonly.
Continue with step 11on the next page.
Notes:
• If the crossover frequency is set to a low value, and the
program material doesn't contain any sounds below
that frequency, the snbwoofer will not output much
sound.
47