Manual

TX NR702,602 t rlbook Page 45 Monday,July 26, 20(14 11:(15 AM
First Time Setup--Continued
TV Format Setup (not American models)
Here you can specify tile TV fonnat used in your area.
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
AM Frequency Step Setup
(some models only)
Here you can specify the AM frequency step used in
your area. When this setting is changed, all radio presets
are deleted.
[RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
Use the Up and Down [A]/[V]
buttons to select "1. Initial
Setup," and then press [ENTER].
The Initial Setup menu appears.
Use the Up and Down [A]/[V]
buttons to select "3. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
Menu
1.Initial Setup
1-3.Hardware Setup
a. Powered Zone2
:Not Activated[_
b.Sp Impedance Minimum
t,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,x,_,,,_tttttttttttt_
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUPI button, arrow buttons,
and [ENTER] button.
Use the Up and Down [A]/[V]
buttons to select "1. initial
Setup," and then press [ENTER].
hfitial Setupmenu appears.
buttons to select 3. Hardware
lSetup," andthenpress[ENTER].
The Hardware Setup menu appears.
Menu
1. Initial Setup
1-3 .Hardware Setup
a. Powered Zone2
:Not Activated{_
b. Sp Impedance Minimum
: 6ohms {_]_
c.TV Format : NTSC_
N
Use the Up and Down [A]/[V]
buttons to select "d. AM Fre-
quency Step," and then use the
Left and Right [<1]/[1_] buttons to
select:
10 kHz: Select if 10 kHz steps are
used in your area.
9 kHz: Select if9 kHz steps are used
in your area.
Press the [SETUP] button.
The setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and IENTER] button.
45