Manual

TX NR702,602 t r_book Page 44 b'Io_day,July 26, 2004 11:05 AM
First Time Setup--Continued
Minimum Speaker Impedance
(not American models)
This setting not set autonqatically by Automatic//
%
is the
peaker Setup function (see page 39). J
If the impedance of any of the connected speakers is 4
ohms or more, but Jess than 6 ohms, set the Minimum
Speaker hnpedance to "4 ohms."
Note:
Before you change this setting, turn down the volume.
1
o,/_.r...o
stagy rv
@®®
¢13@
Au_ su_rrrL_ A_E _aST_
@@@@
@@@@
@O@@
RC'588M
Use the Up and Down [&I/[V]
buttons to select "1. Initial
Setup," and then press [ENTER].
The Initial Setup menu appears.
Use the Up and Down [Al/[V ]
buttons to select "3. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
Menu
1.1nitial Setup
1-3.Hardware Setup
a. Powered Zone2
:Not Activated_
c.TV Format :NTSC_
d.AM Frequency Step
: 9kHz_
(Menus vary depending on country.)
Use the Up and Down [A]/[V]
;_ _}_ ancebUtt°nst°select"b'Splmped"
Mini murn,"and t hen use the
ENT
Left and Right [<1]/[1_] buttons to
select:
! 4 ohms: Select if the impedance of any
connected speaker is 4 ohms
or more, hut less than 6 ohms.
6 ohms: Select if the impedances of all
connected speakers are
between 6 and 16 ohms.
Press the [SETUP] button.
The setup menu Closes.
Notes:
• This procedure can also be performed on the AV
receiver by using its ISETUP] button, arrow buttons,
and [ENTER] button.
44