Manual

TX NR702,602 t rlbook Page 39 Monday,July 26, 20(14 11:(15 AM
First Time Setup
This chapter explains the settings that you need to make before using the AV receiver.
With the supplied speaker setup microphone, the Auto-
matic Speaker Setup fnnction can measure the test tone
output by each speaker and automatically determine the
number of speakers connected, their sizes, the distance
from each speaker to the listening position, and so on.
Before using this flmction, connect and position all your
speakers.
o_o "6"d .......
........ o f>':_, d..
Io0.
....... _ J ._%. irk ))1
1 2
317- l
iiiiiiiiiiiT!iiiiiiiiiiiiiiiiiiiTurn°nthe Vrece'veran the
!7!7!7!7!7!7!7!7!7!7!7!7!7OntheTV,selecttheinpntt°whichthe
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!AVreceiverisconnected.
Put the speaker setup micro-
phone in the listening position,
and connect it to the SETUP MIC
ack
MIC
position
Z
Auto Speaker Setup
Push Enter:Start
grog in the speaker setup
microphone.
Make sure the microphone is hori-
zontal.
If there's an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set the room how you wouM
have it when enioying a DVD.
If the AV receiver was previously
nmted, the Muting function will be
cancelled.
The automatic setup cannot be used
while a pair of headphones is con-
nected.
By putting the microphone close to
where your ears would normally be
at the listening position, a more accu-
rate setup can be achieved. If you use
a tripod or level table, you can adjust
the height of the microphone.
39