Manual

TX NR702,602 t rlbook Page 36 MoIMay,July 26, 20(14 11:(15 AM

Connecting the AV receiver--Continued

For the TX-SR702/702E

The AV receiver's PHONO IN is designed for use with a

moving magnet (MM) type cartridge.

Use an analog audio cable to connect the AV receiver's

PHONO IN L/R jacks to the audio output on your turn-

table, as shown.

jx .................................................................................................................

• Turntable without a Built-in Phono Preamp

Use an analog audio cable to connect an unused audio

input on the AV receiver to the audio outputs on your

phono preamp, and use another analog audio cable to

connect the phono preamp's inputs to your turntable, as

shown.

Notes:

• If your turntable has a gronnd wire, connect it to the

AV receiver's GND screw. With some turntables, con-

necting the ground wire may produce an audible hum.

If this happens, disconnected it.

• If your turntable has a moving coil (MC) type car-

tridge, you'll need a commercially available MC head

amp or MC transformer. Connect your turntable to the

head amp or transformer, and then connect that to the

AV receiver's PHONO IN L/R jacks.

• Yon can also use a phono equalizer to connect a turn-

table with an MC-type cartridge. In this case, see the

phono equalizer's manual for details.

For the TX-SR602/602E/8260

• Turntable with a Built-in Phono Preamp

Use an analog audio cable to connect an unused audio

input on the AV receiver to the andio outputs on your

turntable, as shown.

ii!!iii!i_iiii

.... i;,ill......... !iiii_'i'ii!_ill'_!i!!!'_ii_ii_!_iil

Phono preampI--_= I

• Turntable with an Me (Moving Coil) Cartridge

Use an analog audio cable to connect an unused audio

input on the AV receiver to the audio outputs on your

phono preamp. Use another analog audio cable to con-

nect the phono preamp's inputs to your MC head amp's

outputs. And use another analog audio cable to connect

the MC head amp's inputs to your turntable, as shown.