Manual

m The beginning of audio received by an HDMI IN
can't be heard
Since it takes longer to identify the format of all
HDMI signal than it does for other digital audio sig-
nals, audio output may not start immediately.
N The on screen display does not appear
Depending on the input signal, the on screen display
may not appear when the input signal from the
HDMI IN is output to a device connected to the
HDMI OUT.
50
_l!r;FJrl
Vi/;F4¢]
N There's no picture
Make sure that all video connecting plugs are pushed 16
in all the way.
N Reception is noisy, FM stereo reception is
noisy, or the FM STEREO indicator doesn't light
Relocate your antenna.
Listen to the station in mono. 28
If your TV is connected to the HDMI OUT, select
" in the "ItDMI Input" setup to watch com-
posite video, and component video sources.
39
Passing cars and airplanes can cause interference.
[f the video source is connected to a composite video 18
input, your TV must be connected to the HDMI
OUT or the corresponding composite video output.
While the Pure Audio listening mode is selected, the --
video circuitry is turned off and only video signals
input through HDMI IN can be output.
N There's no picture from a source connected to
an HDMI IN
Reliable operation with an HDMI-to-DVI adapter is 73
not guaranteed. In addition, video signals from a PC
are not guaranteed.
[f nothing improves the reception, install an outdoor --
antenna.
N The remote controller doesn't work
Before operating this unit, be sure to press
RECEIVER.
Install new batteries. Don't mix different types of 4
batteries, or old and new batteries.
Make sure that the AV receiver is not subjected to --
direct sunshine or inverter-type fluorescent lights.
Relocate if necessary.
En
68
ff the message Resolution Error appears on the AV
receiver's display, this indicates that your TV does
not support the current video resolution and you
need to select another resolution on your DVD
player.
N The on-screen menus don't appear
(European, Australian and Asian models) Specify 50
the TV system used in your area in the TV Format
Setup.
When the AV receiver doesn't connect TV with
HDM[, onscreen menus are not displayed.
N The picture is distorted
(European, Australian and Asian models) Specify 50
the TV system used in your area in the TV Format.
Make sure you've selected the correct remote con- 11, 64
troller mode.
Make sure you've entered the correct remote control 63
code.
N Can't control other components
[f it's an Onkyo component, make sure that the 1-41 20
cable and analog audio cable are connected properly.
Connecting only an 1-41 cable won't work.
If you've connected a cassette tape deck, to the TV/
CD INjack, or an R[ Dock to the TWCD IN or
GAME IN or VCR/DVR IN jacks, for the remote
controller to work properly, you must set the display.
25