Manual

Basic Operations
You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT jack are excluded.)
Press RECEIVER followed by DISPLAY repeat-
edly to cycle through tile available information.
You can determine the language used for the onscreen
setup menus. See "OSD Setup" (_ 50).
N Operating on the AV receiver
{iiiiiiiii;{i_;iiiiii!iiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!,,
Use the input selector buttons to select the input
source.
Start playback on the source component.
See also:
• "Controlling Other Components" (_ 62)
• "Controlling iPod" (_ 58)
• "Listening to the Radio" (_ 28)
VOLUME
control.
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes" (_ 32)
• "Audyssey" (_ 45)
N Operating with the remote controller
i
Press RECEIVER followed by INPUT SELEC-
TOR.
Start playback on tile source component.
See also:
• "Controlling Other Components" (_ 62)
• "Controlling iPod" (_ 58)
• "Listening to the Radio" (_ 28)
To adjust tile volume, use VOL t/V.
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes" (_ 32)
• "Audyssey" (_ 45)
• Alternatively, you call use the AV receiver's DISPLAY.
The following information can typically be displayed.
Input source &
volume*l _.':::_'"_...'_'"____'"_ ,::LS.:?
Signal format*2
or sampling fre........
quency
Input & output
resolution .,............... : . ...., ,..., . .:. ,..., ,......... :
Input source &
listening mode*3
Ill............................................................................................................................................
"1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is analog, no format information is dis-
played. If the input signal is PCM, the sampling frequency is
displayed. If the input signal is digital but not PCM, the signal
format is displayed.
Information is displayed for about three seconds, then the pre-
viously displayed information reappears.
*3 The input source is displayed with the default name even
when you have entered a custom name in "Name Edit"
(÷ 47).
You can adjust the brightness of the AV receiver's display.
Press RECEIVER followed by DIMMER repeat-
edly to select: dim, dimmer, or normal brightness.
• Alternatively, you can use the AV receiver's DIMMER (North
American and Taiwan models).
ED
23