Operation Manual

RIConnectionandSetting
ConnectanOnkyocomponentwithRIjacktothisunitusinganRIcableand
ananalogaudiocable.Fordetails,refertotheinstructionmanualofthe
componentwithRIjack.TheRIcablecanbeconnectedinanyorder.When
therearetwoRIjacks,bothjacksworkinthesamewayandare
interchangeable.
ThefollowingsettingsarenecessarytoconnecttheRIDockorcassettetape
deckviaRI.
Torenametheinputselector
TomaketheRIfunctionswork,youmustrenametheinputselectorsonthe
unit.AfterpressingRECEIVERtoswitchtoRECEIVERmode,pressSETUP
ontheremotecontroller.UsethecursorsintheSetupmenutoselect"4.
Source""NameEdit""Name"andrenametheinputselectorto"DOCK"or
"TAPE".
ToprogramtheRIremotecontrolcode
ProgramtheremotecontrolcodetoanyREMOTEMODEbuttononthe
remotecontroller.Thiswillallowyoutooperatethecomponentbypointing
theremotecontrollerattheunitinsteadofthecomponent.
1. PressandholdDISPLAYfor3ormoresecondswhileholdingdownthe
REMOTEMODEbuttontowhichyouwanttoprogramtheremotecontrol
code.
Connecting and Operating Onkyo RI Components