Operation Manual

Others
Power consumption in standby mode
In the following cases, the power consumption in standby mode may
reach up to a maximum of 55 W:
– When "HDMI CEC (RIHD)" is set to "On". (Depending on the TV
status, the AV receiver will enter normal standby mode.)
– When "HDMI Through" is set to other than "Off".
The sound changes when I connect my headphones
When a listening mode other than Direct, or Mono is selected, connecting
a headphone automatically selects Stereo.
How do I change the language of a multiplex source
Select "Main" or "Sub" for "Input Ch(Mux)" in "8. Audio Adjust".
The RI functions do not work
To use RI, you must make an RI connection and an analog audio (RCA)
cable between the component and AV receiver, even if they are
connected digitally.
While Zone 2 is selected, the RI functions do not work.
The functions System On/Auto Power On and Direct Change do not work
for components connected via RI
These functions do not work when Zone 2 is turned on.
The display is dark
Make sure that Dimmer function is not working. Press DIMMER button
and change the brightness level of the display.
The following settings can be made for the composite video inputs
While holding down the input selector button to configure, press HOME
once at a time until "Video ATT: On" is appeared on the display. To
resume the setup, repeat the above described step until "Video ATT: Off"
is appeared on the display.
This setting is possible for input selectors assigned with one of the video
inputs "VIDEO 1" to "VIDEO 3" in "3. Composite". If you have a game
console connected to the composite video input, and the picture is not
very clear, you can attenuate the gain.
Video ATT: Off: (default).
Video ATT: On: (Gain is reduced by 2 dB.)
Troubleshooting