Operation Manual

The Late Night function does not work
Make sure the source material is Dolby Digital, Dolby Digital Plus, or
Dolby TrueHD.
About DTS signals
When DTS program material ends and the DTS bitstream stops, the unit
remains in DTS listening mode and the dts indicator remains on. This is to
prevent noise when you use the pause, fast forward, or fast reverse
function on your player. If you switch your player from DTS to PCM, you
may not hear any sound because the unit does not switch formats
immediately. In such case, you should stop your player for about 3
seconds and then resume playback.
With some CD and LD players, you will not be able to playback DTS
material properly even though your player is connected to a digital input
on the AV receiver. This is usually because the DTS bitstream has been
processed (e.g., output level, sampling rate, or frequency response
changed) and the AV receiver does not recognize it as a genuine DTS
signal. In such cases, you may hear noise.
Playing DTS program material, using the pause, fast forward, or fast
reverse function on your player may produce a short audible noise. This
is not a malfunction.
The beginning of audio received by an HDMI IN can not be heard
Since it takes longer to identify the format of an HDMI signal than it does
for other digital audio signals, audio output may not start immediately.