Operation Manual

RI connection and settings
Connect an Onkyo component with RI jack to the unit using an RI cable and
an analog audio (RCA) cable. For details, refer to the instruction manual of
the component with RI jack. The RI cable can be connected in any order.
When there are two RI jacks, you can connect to either one as both jacks
work in the same way.
To connect the RI Dock or cassette tape deck via RI, you must:
Renaming the Input Selector
To make the RI functions work, you must rename the input selectors. Press
RCV on the remote controller to switch its mode to RECEIVER mode and the
press HOME. Select "9. Source Setup" in "Setup" menu and rename the
input selector by setting "DOCK" or "TAPE".
Program the RI remote control code
Program the remote control code to desired REMOTE MODE button on the
remote controller. This will allow you to operate the component by pointing
the remote controller at the unit instead of the component.
1. Press DISPLAY for 3 or more seconds while holding down the REMOTE
MODE button to which you want to program the remote control code.
The remote indicator lights.
The RCV, ZONE2, and TV buttons cannot be programmed.
Connecting and Operating Onkyo RI Components