Manual

Using a Macro function
STDBY
Erasing all commands and macros that have
been programmed
This procedure will erase all the commands and macros that you
have programmed into the remote controller and return it to its
default selfings. This operation will not affect the preset settings of
the remote controller.
t.
2.
3.
Open the battery cover and remove the batteries from
the remote controller.
While pressing and holding down the ON and STDBY
buttons, re-insert the batteries in their correct
orientation, and then release both buttons.
The SEND/LEARN indicator flashes slowly.
Press the ENTER button.
The SEND/LEARN indicator lights up for about ten seconds and
then turns oft'.
®®®®
c_ c_ c_
ENTER
All programmed commands and macros are erased and the remote
controller returns to its factory presets.
Notes:
• Proceed to Step 3 immediately after Step 2; otherwise, the
batleries will be consumed quickly.
• If you press any button olher than the ENTER button in Step 3,
nothing will be erased. In this case, resume from Step 1.
Macro mode programming memo:
MACRO MODE MODE MODE MODE MODE MODE MODE MODE DIRECT
MACRO MACRO MACRO MACRO MACRO MACRO MACRO MACRO MACRO
$ ,L ,L ,L ,L $ $ $
RCVR CD DVD MD SAT CABLE VCR TV
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Operation 12
Operation 13
Operation 14
Operation 15
Operation 16
69