User Manual
6
Rear Panel
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input digital audio signals from an external device
with a digital optical cable or digital coaxial cable.
2. REMOTE CONTROL jack: An Onkyo product with RI jack can be connected and
synchronized with this unit (P10).
3. USB jack: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (maximum 5 V/1 A) to USB devices with a USB cable.
4. ETHERNET jack: Connect to the network with an Ethernet cable.
5. Wireless antenna: Raise for Wi-Fi connection or when using a BLUETOOTH wireless
technology enabled device. Adjust their angles according to the connection status.
6. IR IN/OUT terminals: Connected to the multi-room remote control kit. Special devices or
cables are necessary. For more information about preparation, contact the specialized
stores.
7. Power cord
8. GND jack: The ground wire of the turntable is connected.
9. FM 75≠/AM ANTENNA jacks: Connect the supplied FM indoor antenna and AM indoor
antenna.
10.
LINE IN jacks: Input audio signals from an external device with an analog audio cable.
11.
LINE OUT jacks: Connect a recording device, such as a cassette tape deck. Connect to
the LINE IN jacks on the recording device using analog audio cable.
12.
SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a subwoofer cable.
13.
ZONE 2 PRE OUT jacks: Output audio signals with an analog audio cable to a pre-main
amplifier or power amplifier in a separate room (ZONE 2) (P27).
14.
SPEAKERS jacks: Connect speakers with speaker cables. You can connect a set of left
and right speakers to each of the A/B terminals. (This unit is banana plug ready)
> Before Start >Part Names > Install > Initial Setup > Playback
Supplementary information | Advanced Setup | Others
180°
90°
SN29403233A_TX-8260_En.book 6 ページ ２０１７年１０月１７日 火曜日 午後２時４５分