Owner's Manual

Troubleshooting

If you have any trouble using the T-4555, look for a solution in this section.

Can’t turn on the T-4555.

• Make sure that the power cord is properly plugged into the wall outlet. And also, make sure that the other end of the

power cord is properly connected to the T-4555’s AC INLET (see page 10).

• Unplug the power cord from the wall outlet, wait 5 seconds or more, then plug it in again.

There’s no sound.

• Make sure your ampliﬁer’s volume control is not set to minimum.

• Check all connections and correct as necessary (see pages 11 to 15).

Reception is noisy, stereo FM reception suffers from hiss, or the STEREO indicator doesn’t light up when tuned

to a stereo FM station.

• Check the antenna connections (see page 11).

• Change the position of the antenna (see page 17).

•Move the T-4555 away from a nearby TV or computer.

• Cars or airplanes can cause noisy interference.

• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.

•Try selecting Manual Tuning mode (see page 16).

•Move power cords and speaker cables as far away as possible from the antenna.

• When listening to an AM station, noise may be heard when you operate the remote controller.

• If none of the above improves the reception, install an outdoor antenna (see page 12).

If a power outage occurs or the power cable is disconnected:

• If the preset stations are lost, preset them again (see page 30).

Can’t adjust the frequency of the radio.

• Use the TUNING/CH [ ]/[ ] buttons to change the frequency of the radio (see page 16).

RDS doesn’t work.

• The FM station you are tuned to doesn’t support RDS.

• Install an outdoor FM antenna (see page 12).

• Change the position or direction of your outdoor FM antenna (see page 12).

•Move the FM antenna as far away as possible from ﬂuorescent lights (see page 12).

Power

Audio

Tuner

If you can’t resolve the issue yourself, try resetting the T-4555 before contacting your Onkyo dealer.

To reset the T-4555 to its factory defaults, turn it on and, while holding down the

[MEMORY] button, press the [STANDBY/ON] button. “Clear” will appear on the

display and the T-4555 will enter Standby mode.

Note that resetting the T-4555 will delete your radio presets and custom settings.

T-4555_En.book Page 32 Wednesday, March 19, 2008 9:14 AM