Instruction Manual

2
Firmware Update for the TX-NR3009, TX-NR5009 & PR-SC5509
We are pleased to offer this firmware update for the best possible performance of your AV Receiver.
A firmware update is now available through the Network or USB connections on the TX-NR3009, TX-NR5009
and PR-SC5509
To check if your firmware is the latest version, go in to Setup -> Hardware Setup -> Firmware Update and
check the 16 digit number. (1081-0800-0210-6104)
If any of the numbers differ from the latest version available, please update your unit.
Information Concerning Firmware Update for Onkyo Network Receivers
Onkyo has discovered there is a possibility of failure when updating receivers to this new firmware
package via ethernet in certain network environments. For this reason, we are now only releasing a
firmware file for installation via USB port / flash memory device.
Should you encounter any difficulties when performing this update, please
contact us.
We appreciate your understanding and apologize for any inconvenience this issue may cause.
Latest Firmware Version: 1081-0800-0210-6104
The 02/19/14 update addresses the following: AVAILABLE ONLY VIA USB
1. Corrects lock up failure when using Telstra T Box or MiCasaVerde Vera Lite controller on the same
network
2. Addresses format changing of Rhapsody
The 09/11/13 update addresses the following (all above listed models): AVAILABLE ONLY VIA USB
1. Improves picture output of 4K up-scaling
The 7/5/2012 update addresses the following:
1. Improves the operation when HDMI Through is set to on
2. Stabilizes the operation of Network Control
3. Corrects the video output when the Picture Mode is set to Through
The 3/16/2012 update addresses the following:
1. Stabilizes video output when using HDMI/CAT5 Extender on HDMI OUT MAIN terminal
The 12/20/2011 update addresses the following:
1. Improves noise during playback of DTS-HD Master Audio with particular Blu-ray disc
2. Corrects operation of Audyssey MultiEQ XT32 in Bi-Amp mode
The 10/31/2011 update addresses the following: