Owner's Manual

Other Information
49
Using timer functions
Sleep timer
The sleep timer puts the NC-500 into standby
mode when the set time elapses.
The sleep timer can be configured from the
remote controller only.
Press the SLEEP button to set the time that must
elapse before the NC-500 is put into standby
mode.
When you press the SLEEP button on the remote
controller for the first time, the “SLEEP90”
appears in the display, meaning that the NC-500
will be put into standby mode after 90 minutes.
Subsequently, each time you press the button, the
time setting is reduced in decrements of 10
minutes.
You can use the Cursor
/ button to change the
time setting in minutes.
While the sleep timer function is set, “[Sleep]”
appears in the display.
To disable the sleep timer setting, press the
SLEEP button repeatedly until “SLEEP”
indication disappears.