User's Manual

Tip

• If the controller is turned off or enters the standby

mode, also the subwoofer enters the standby mode

in 30 seconds. In this mode, the controller

automatically detects a pairing point and

reconnects. The subwoofer is automatically turned

on when the link is recovered.

Note

• Depending on the reception condition, the sound

might be stopped or interrupted while using. This is

not a malfunction. In this case, change the place or

direction of the controller or the subwoofer.

• If the controller and the subwoofer are too far, the

reception might be unstable. They should be placed

within 32 ft. (10 m).

• If there is an obstacle (metal door, concrete wall and

insulation contained aluminum foil, etc.) between

the controller and the subwoofer, it might block the

reception and stop the sound. Place the controller

and the subwoofer in good visibility with each

other.

The controller contains a microcomputer for

signal processing and control functions. In

very rare situations, severe interference,

noise from an external source, or static

electricity may cause it to lockup. In the

unlikely event that this happens, unplug the

power cord from the wall outlet, wait at least

five seconds, and then plug it back in.

Onkyo is not responsible for damages (such

as CD rental fees) due to unsuccessful

recordings caused by the unit’s malfunction.

Before you record important data, make sure

that the material will be recorded correctly.

Before disconnecting the power cord from

the wall outlet, set the controller to standby.

E52_LS3100_120910.book 24 ページ２０１２年９月１０日　月曜日　午後４時３０分

TENTATIVE